How to Clean the Joyetech eGo AIO
To clean the Joyetech eGo AIO you just need some isopryl alcohol or grain alcohol. Empty the tank and hold upside down. Swish some alcohol around the inside with a cotton swab or lint-free rag until all of the ejuice is removed.
Repeat with warm water and dry. If you have an extra device, you can use that while the other one dries. Or, take a dry cloth and dry the inside before using.
Advisable to change out the coil for a new or cleaned one.
How to Clean and Reuse Coils – Joyetech eGo AIO
To save some money, you can also clean the Joyetech eGo AIO coils and reuse them. I would say you might get two more uses out of each coil once they’re cleaned. It’s a hit or miss; sometimes it works, sometimes not.
- Bring a pot of water to a full, rolling boil.
- Place coils in the boiling water for 10 minutes, stirring them around every few seconds.
- Place coils on a dry paper towel or tissue and allow to dry for a few hours. I left mine sit overnight before reusing them.
You have to prime the coil again just as you would a brand new coil. Once they’re clean, I put them back into an empty coil box to reuse.
You can even clean sub-ohm and RDA coils the same way!